Disclaimer: This guide is intended for professional installation. Improper installation may void the manufacturer's warranty. Ensure all local safety regulations are followed during every phase of the process. Share public link
: Power down the primary Challenger control panel and any auxiliary power supplies.
: The open collector output switches low to activate low-current door relays or electronic door strikes directly. For high-power locks, always route this output through an interposing power relay. Step 5: Final Assembly and System Commissioning
This section is the most critical part of the installation. Miswiring can lead to malfunction or permanent damage. 4.1 Wiring Overview ts1162 installation manual exclusive
At ambient temperature (no load), run the TS1162 at 5% of rated speed for 10 minutes. Place a mechanic’s stethoscope on four points: front bearing, rear bearing, gear case, and sensor housing. You should hear . High-pitched squealing indicates bearing misalignment. Clicking indicates a loose rotor magnet.
: Installation should be performed by trained security technicians. If electrical wiring for a power outlet (GPO) is required, you must use a qualified electrician .
The TS1162 typically features switching capabilities. This means it can switch two separate circuits simultaneously, or one circuit while keeping one neutral pass-through. Share public link : Power down the primary
If you want to optimize your panel configuration, let me know: Tecom TS1162 datasheet - Aritech
Tecom Titan - Default Password & Password Reset Instructions
[Challenger Panel LAN Terminal] <====== Twisted/Shielded Pair ======> [TS1162 Keypad Terminal] Positive (+) ---------------------------------------------------- Positive (+) Negative (-) ---------------------------------------------------- Negative (-) Ground (GND) ---------------------------------------------------- Ground (GND) Advanced On-Board Connections Step 5: Final Assembly and System Commissioning This
: Connect to the positive differential transmission line of the RS-485 data bus.
: Wire the RS-485 twisted data pair directly to the corresponding LAN A and LAN B data terminals. Auxiliary Hardware Connections
Configure the specific security areas that this keypad will arm, disarm, or access.