All GC-2010 models have a robust self-diagnostic system. When an error occurs, an alarm sounds and a code is displayed. These codes are essential for accurate troubleshooting.
Remove the FID cap, collector cover, and disconnect the igniter filament and signal cable.
: Supports up to three simultaneously installed detectors, including FID (Flame Ionization Detector), TCD (Thermal Conductivity Detector), ECD (Electron Capture Detector), and FPD (Flame Photometric Detector). Routine Maintenance Procedures shimadzu gc-2010 service manual
Best performance is constrained within a stable range of 18–28°C.
Inspect the SSR (Solid State Relay) on the right-side electronics panel. If the SSR fails open, power cannot reach the heating elements. All GC-2010 models have a robust self-diagnostic system
: Uses Advanced Pressure Controllers (APC) for digital setting of detector gas parameters and high-precision flow control.
Fit a new O-ring onto a clean, deactivated glass liner, positioning it roughly 2–3 mm from the top edge. Insert the new liner smoothly into the port. Remove the FID cap, collector cover, and disconnect
Inspect the split vent trap filter every six months. A clogged filter restricts split flow, leading to erratic split ratios and reproducibility issues. Column Installation and Conditioning